www.etrailer.com Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information. Today we are going to be installing Valley hitch part number V82790 on a 2007 Toyota Tacoma. We are looking at the passengers side frame rail, and you can see at the end here we have got two existing weld nuts. Those are going to provide the attaching points for the trailer hitch on the frame. We are going to be using the same weld nuts on the drivers side. There are also going to be two attaching points here at the bumper. You can see at the bottom we have got three existing holes. We are going to be using the two outer holes as attaching points as well. We are actually going to be taking the part of the cover off here, the step bumper, and ping bolts down through there, where we are going to attach it to the hitch. The first thing we are going to do is to go ahead and remove the cover from the bumper so we can our bolts down. And we also want to check our weld nuts to see if they need to be cleaned. To get the caps off the bumper cover, I am going to go ahead and remove the whole thing and then pop them out. To do that, you can see here on the underside of the bumper we have got two screws here that are holding the bumper cover on. So I am going to go ahead and remove those and then pop it off. OK, and then here on the upper side of the bumper cover we are going to remove these two little tabs and these little push pins in there. We ...
Tags: etrailer.com, V82790, trailer, hitch, receiver, install, installation, 2007, 07, toyota, tacoma, valley
No comments:
Post a Comment